Vertical Extrusion

In this dialog, you set the depth of your extrusion. This can be done by:

1. Moving the origo to a surface located right above/below the input feature (Feature to Follow).

2. Selecting the depth to be a fixed offset (Vertical Offset).

3. Moving the origo to a surface located right above/below the input feature with an additional offset (Feature to Follow + Vertical Offset).

4. Moving the origo to the lowest z value of the surface under the input feature. (Feature to Follow + Extrude to Lowest Surface Point).

5. Moving the origo to the lowest z value of the surface under the input feature with an additional offset (Feature to Follow + Extrude to Lowest Surface Point + Vertical Offset).

It is also possible to calculate an offset by using the Feature to Follow.

Next topic: Extrude to Lowest Surface Point